Cru DataPAK Manual do Utilizador descarregar pdf (Página 7)

Page 7

3.1.2 Hot Spares (Host Standby)

RAIDs 3 and 5 are two RAIDs available with DataPAK that will support hot spares. Hot

spares are drives connected as part of your RAID that are switched into operation with a

drive in the RAID fails. In other words, if you setup “3+ Host Standby” with your RAID 3

or 5, then the DataPAK will immediately rebuild the RAID in the event that a drive fails.

After the RAID has rebuilt the DataPAK will need to be powered down and the failed drive

should be replaced preferably with the same model of drive.

4. RAID Conﬁguration (Skip ahead if you purchased a pre-conﬁgured unit.)

To set up your RAID you’ll need to use Conﬁgurator 3.0. If you have not already installed

Conﬁgurator 3.0 then follow the steps below. If it is installed on your computer then skip

below to section 4.1.2.

4.1 Conﬁgurator 3.0

4.1.1 Installing Conﬁgurator

Conﬁgurator 3.0 can be found on our webpage (http://www.cru-dataport.com/software/

conﬁgurator.php)

•Toinstallfromtheweb,gotothewebpageandselecttheConguratorthat’scompat-

ible with your Mac or Windows Operating System.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Sem comentários

Cru DataPAK Manual do Utilizador Página 7